Flight Controller setup

Mission Planner Configuration

Telemetry Radio V3 configuration:

Set a different Net ID for each pair of Telemetry Radio V3, as shown below

Connect all telemetry modules to the computer via a USB hub.

Open Mission Planner to locate the base, then connect it withthe flight controllers. Select AUTO connecting as shown below. All recognized flight controllers on the ports will be connected.

You may select the UAV from the dropdown list below:

QGC Ground station configuration:

1. Connect the flight controller via USB and set an ID for each flight controller that is different from other flight controllers.

  1. Turn off auto-connect in QGC

  1. Add manual connection

  1. Connect all UAVs one by one.

  1. After the connection is complete, you may select the UAV from the dropdown list below:

Last updated

Was this helpful?